Anchor NAV50-1204 Manuale Utente

50’ Wide SystemQuality, Craftsmanship and Service since 1892NAV50-1204Copyright © Anchor Industries 2004Please read all assembly / installation instru

9SQUARE UNIT TOPFRAME COMPLETESUMMARYOF STEPS FOR COMPLETING THE SQUARE TENT1. INSTALL OPPOSITE EAVES, RAFTERS, HIPS ANDHIP BRACES TO COMPLETE SQUARE

10LIFTING TOP FRAME(FIRSTSIDE)INSTALL UPRIGHTS. AT INTERMEDIATELOCATIONS, INSTALL UPRIGHT BRACESAS WELLUPRIGHT BRACESUSING HEAVY-DUTY NAVI=TRAC FRAM

11TENSIONING AND GUYING1. USE WEB/RATCHETS TO SECURE CATENARY ARCHES TOUPRIGHTS, STAKE BASEPLATES BEFORE TENSIONING WEBS.2. ATTACH GUY WEBS TO EAVE

12HIP END MODULES FOR RECTANGULAR UNITSTHE RECTANGULAR UNIT IS SIMPLY (2) HIPENDS FACING EACH OTHER AND SEPARATEDBY PARALLEL-BEAMED MIDDLE BAYS.NOTE:

13INSTALLING MID BAY PURLINS AND EAVE/RIDGE BARSFOR MOST EASE, INSTALLIN THE ORDER SHOWNFOR PURLINS & EAVE/RIDGE BARS,INSTALL HOOK END FIRST, THEN

14INSTALLING MID PANELINSERT FINGERS OF WHEELED PANEL GUIDE INTO THE OPEN END OF THE RAFTER AND WELDMENT. TIGHTEN THE BUTTERFLY NUT. REVERSE FOR OPP

15UNITS WITH (2) OR MORE MID BAYSADDITIONAL GUIDE BARS CAN BE PURCHASED123MIDDLE BEAMS THAT ARE NOT A PARTOF AN END MODULE USE THE HINGED BASEPLATE (F

50’ NAVI-TRAC COMPLETEWITH (2) 20’ MID BAYS1. SIDEWALLS MUST BE ADDED TO COMPLETE THE UNIT (SEE BLUEPRINT INFORMATION).2. INSTALL, STAKE, AND TENSIO

EVANSVILLE, INDIANA28.3 11-01-02Thank you for purchasing an Anchor product. In return, we pledge Quality, Serviceand Craftsmanship and are available

IndexTABLE OF CONTENTSPage No. Assembly Step2 Squaring Footprint and Laying out Uprights3 50’ NAVI-TRAC component list and Hardware Location Chart4 In

DIRECTIONS FOR SQUARING THE TENT1. USE A TAPE MEASURE TO MARK THE ENDS OF A LINE FOR ONE END (A TO B ABOVE)EQUAL TO THE EXACT WIDTH OF THE UNIT.2.

350’ NAVI-TRAC COMPONENT LIST3-BHARDWARE LOCATION CHART3-T

450’ Navi-Trac Frame TerminologyINTRODUCTION:The NAVI-TRAC frame configuration is based onthe hip roofed square tent shown at right. Hip bars connect

50’ NAVI-TRAC COMPONENT ILLUSTRATIONS5-T5

50’ NAVI-TRAC INSTALLATION SAFETY GUIDELINESYour installation techniques will evolve to fit the needs of your clients, the experience level of your cr

LAYOUT END MODULE COMPONENTSCONSTRUCT FIRSTBEAMNOTE: ON END MODULES, EAVE FITTINGS FOR BOTHEAVES AND RAFTERS ARE RIGID SLIP JOINTS.HOOK THE END RAFTE

1342657INSTALL DROP-IN HIPS AND HIP BRACES IN THE ORDER SHOWN.HINT: TO ALIGN HIP BRACES , LIFT CENTER OF HIP BAR, THEN DROP THE HIP BRACE CONNECTORS